Henan Liming Heavy Industry Science & Technology Co.,Ltd
News  >  features >  Jaw Crusher common troubleshooting methods(1)

Jaw Crusher common troubleshooting methods(1)

The host suddenly stands (commonly known as: boring vehicles)
Reasons:
1) nesting inlets, resulting in blocking material filled with
2) The driver of the triangular groove round rotating belt too loose, resulting in a belt slipping
3) eccentric bushing axis tight set loose, causing the rack on both sides of the bearing with no gap, so that stuck eccentric shaft can not rotate
4) low voltage workplace, host大料encountered, the inability to broken
5) bearing damage.
Troubleshooting:
1) removal of nesting material inlets to ensure the smooth flow of materials
2) tighten the belt or replacement of the triangular
3) to re-install or replace the bushing tight set
4) transfer of the voltage is the workplace to meet the requirements of the host operating voltage
5) the replacement of bearings.

2. Host slot round, moving jaw functioning normally, but broken cease work
Reasons:
1) tension spring fracture
2) rod fracture;
3) loss or board elbow fracture
Troubleshooting:
1) the replacement of spring tension
2) replace the bar
3) to re-install or replace the toggle plate

Yield less than the standard factory
Reasons:
1) the hardness of materials has been broken or toughness more than the scope of the provisions of Manual
2) the location of electrical wiring then the anti-, host-opened anti-vehicle (moving jaw clockwise rotation), or electrical connection triangle then connected into a star-shaped
3) the provisions of nesting population is less than the limit
4) displacement of the jaw plate, top with the gear teeth relative top
5) low voltage field work
6) moving jaw and bearing wear too much space, so that the relative occurrence of bearing outer ring rotation
Excluded:
1) to replace or increase crusher
2) change the electrical wiring;
3) nesting I adjusted to the provisions of the public statement that I and the increase in nesting chronology for the Breakers
4) check from the tooth Bandicota size, such as sub-standard replacement jaw plates to be, transferred is fixed jaw plate and the activities of the relative position of the jaw plates to ensure the tip of the tooth root, the fixed-pressed to prevent the displacement of
5) to increase the voltage of the workplace to meet the requirements of the host heavy-duty
6) the replacement of bearings or moving the jaw

The activities of the jaw plate and fixed working hours have beat or percussive sound
Reasons:
1) the jaw plate fastening bolts loose or falling
2) nesting population is too small, the two hit each other at the bottom of the jaw plate
Excluded:
1) fixed or fully tight bolts
2) nesting population transfer is to ensure that the correct two jaw plate gap

Toggle plate fracture
Reasons:
1) host overload or greater than the size of feed material into the
2) a non-broken material into the crushing chamber
3) plate with the toggle plate elbow pad parallel between, there are skewed
4) Casting Foundry who have more severe defects in
Excluded:
1) the replacement bracket and feed particle size control and to prevent overloading the host;
2) replace the brackets and to take measures to prevent the non-broken material into the crushing chamber;
3) the replacement bracket and the replacement of the bracket pad wear, the correct installation bracket
4) Qualified replacement bracket

Copyright © 2004-2014 Henan Liming Heavy Industry Science & Technology Co.,Ltd. All rights reserved
Tel: 0086-371-86162511   Fax: 0086-371-67992699   E-mail: lmzz_jkj@break-day.net